The IS220PTURH1A is a component created by GE for their Mark VI system. The Mark VI is one of the final Speedtronic systems for gas/steam turbine management that was released by GE.
The IS220PTURH1A is a Primary Turbine Specific Primary Trip pack. This component provides an electrical interface between a turbine control terminal board and either one or two Ethernet networks. Outputs from this pack occur through a DC-62 pin connector that connects to an associated terminal board.
The IS220PTURH1A is built with a black outside casing with openings for air circulation. The front of this case has multiple LED indicators, as well as an IR (infrared port.) This port is not used in this pack. Inside this casing, there is a processor board, a second board specific to turbine control, and an analog acquisition auxiliary board. The pack mounts to the TTURH1C terminal board. The processor board has two 10/100 Ethernet ports, flash memory, and RAM, a read-only chip for identification, an internal temperature sensor, and a reset circuit.
The IS220PTURH1A allows for Auto-reconfiguration, which will automatically download from the controller to the I/O pack. The reconfiguration includes baseload, bootload, firmware, and parameters. Auto-reconfiguration must be enabled for this to occur. This is enabled or disabled in the Toolbox ST application through the Component Editor.
The IS220PTURH1A has an interface with four passive, magnetic speed inputs. Circuit sensitivity can allow detection of 2-RPM turning gear speed to determine if the turbine has dropped to zero speed (turbine has stopped.) The median speed signal on the pack is used for speed control and for primary overspeed trip signal.
VMIVME-7750
IS220PVIBH1A
IS420UCSCH2A
5SHY3545L0010 3BHB013088R0001
3BHE009681R0101 GVC750BE101
ICS TRIPLEX T8310
ICS TRIPLEX T8461
ICS TRIPLEX T8151B
ICS TRIPLEX T8403C
ICS TRIPLEX T8311
ICS TRIPLEX T9402
ICS TRIPLEX T9451
IS215VCMIH2BB
IS215VCMIH2CA
ABB PM866K01 3BSE050198R1
ABB 216NG63
ABB 216VC62a
ABB 216EA61b
ABB 216AB61
ABB 216DB61
ABB REG216
PC control module, is based on PC as a basic development of a control terminal. PC control module is a programmable controller, is used for communication between PC and PC station terminal, mainly used to achieve control data communication function. PC control module has powerful functions, good compatibility, high security, cheap price, simple maintenance, support industrial environment and other characteristics. According to customer requirements for secondary development and production, with high cost performance. PC control module through serial communication technology and analog/digital communication technology and PLC, MCU and other control equipment to achieve communication, can be used in PLC, MCU and other control equipment.
We do other brands: ABB, Allen-Bradley, Schneider, GE (General electric), Westinghouse, FANUC, Bently, KUKA, Foxboro, Triconex, Honeywell, YASKAWA, etc., if you need, you can contact me, look forward to your consultation.
As long as tomorrow is still here, as long as spring is still here!
As long as there is life, as long as there is hope!
As long as tomorrow is still here, as long as the future is still here!
